About Our Muncie Metal Roof Coating Work
Restoring Commercial Roofs Through Prep You Can Check Yourself
Here is more about our Muncie metal roof coating work: how we inspect, prep, and coat commercial roofs, and how each step is recorded for you.
- Every JobStarts with a roof walk
- Every CoatThickness measured
- Every OwnerGets a written scope
More About Our Muncie Metal Roof Coating Work
The short version about our Muncie metal roof coating work: inspection decides the job, prep takes most of the time, and the coating goes on at a measured thickness.
We coat commercial buildings only: plants, warehouses, shops, offices, clinics, churches, and farm buildings used for business. Every roof gets a written scope before work is scheduled, so you know which screws, laps, and curbs get attention.
- Roof walk, moisture readings, and photos on every job
- Prep written out screw line by screw line
- Wet film readings logged as coats go on
Want to See the Roof Before You Decide?
We walk the roof with you and point out what we would fix and why. Call to set a time that works for you.
Phone: (463) 466-9855
What the Inspection Covers
Every roof walk follows the same list. You get photos of anything we flag.
Panels and Paint
Chalking, rust spots, rust-through, and any panel that flexes or lifts underfoot.
Screw Lines
Backed-out screws, split washers, stripped holes, and rust rings around heads.
Laps and Seams
Side and end laps, ridge caps, and any seam where old sealant has shrunk.
Curbs and Penetrations
Rooftop unit curbs, skylights, vents, exhaust fans, and pipe boots.
Gutters and Edges
Gutter seams, outlets, eave trim, and signs of ice backing up in winter.
Insulation Moisture
Meter readings across the roof, with test cuts where readings run high.
Inside the Building
Stains, drips, and condensation under the roof, matched to what we found above.
What We Will Not Do
A few things stay off the table on every job. Here is each one and what we do instead.
| We Will Not | What We Do Instead |
|---|---|
| Coat over wet insulation | Replace the wet sections first so water stays out of the roof |
| Coat over rust-through holes | Patch or replace the steel, then prime and coat |
| Skip the screw lines | Tighten, upsize, or replace screws and seal every head |
| Mix coating families on a recoat | Keep the recoat in the same family as the system |
| Coat failing shingles | Recommend repair or replacement for curled or soft roofs |
| Guess at thickness | Take wet film readings and record them |
| Promise a lifespan | Explain what affects coating life on your roof |
Questions About Our Muncie Metal Roof Coating Work?
Ask us anything about the process, or answer seven questions for a ballpark range on your roof.